To complete the whole process, you must understand the basics of installing a garage door. In fact, anyone can do it within a few hours. This article will help you get you all the details to understand the basics of garage door installations. To complete it, you will need tools, help and time. The following are the 3 basic steps that needs to be understood first before you start the installation process.
Preparation Phase. Before you start your work, make sure to review the whole process on your manufacturer’s manual. The steps that you will need to anticipate and the tools you are going to need are both important things you will know by reading the manual. It is important to know that all the instructions on the manual will supersede any other guides. After reviewing the manual, make an inventory of all the parts you are going to need. Usually all the parts are listed in the manual. To organize the parts into piles for easier process is highly suggested. Including a ladder, gather all the tools and materials you are going to need. To prepare the first panel for installation is the last task in this phase. You can leave the hinges on left and right into the roller.
Installation Phase. The first panel must be able to cover the opening. Garage doors are about 7 feet high and 9 feet wide for standard types. All of these, curved parts, vertical and horizontal of the track, are separated and attached in separate steps. The vertical track is recommended to be installed first using slide rollers onto end of the track of the first panel. It must be lowered in place. Tracks are installed in the center of the opening. Tighten the brackets all the way until the next panel. It is best to get help when installing the second panel because the outside hinges must be attached first before the panel can be put in place as suggested by the experts from Durham Garage Door Installation. The hinges and rollers are subsequently installed. Don’t forget about pre-drilling the holes before you install the second one. The track up the wall, the door level, and the vertical track, all must be secured and plumb. The torque tube and curved tracks is advised to be installed by a professional to avoid repeating the whole process.
If You Think You Get Doors, Then This Might Change Your Mind
Post-Installation Phase. Don’t forget to remove nails that are jamb across the first panel. If it is necessary, make adjustments to position the track. Finally, check the operation of the door working up and down.
Short Course on Installations – What You Need To Know
These 3 basic steps will surely help you complete a garage door installation successfully.